Minetrax Oem Static Modem-tag-router

MineTrax OEM Static Modem/Tag/Router Module

Model Number: MTX-OEM-200-S

Highlights:

Fixed two-way data communications
RFID tagging
Multihop backhaul routing

MineTrax Networking

RF front end:

902-928 MHz
Antenna connector: RPSMA, MMCX or direct soldering
TX radiated power: -1 dBm up to +14 dBm
RX sensitivity: -105 dBm
64 x 200 kHz channels
Typical omnidirectional range in underground mines: 50 m to 150 m depending on antenna placement, tunnel dimensions and curvature, obstructions and rock type
Typical omnidirectional range on surface: 50 m to 600 m depending on antenna placement and obstructions

Mesh networking protocol:

16-bit network address
Ad hoc self-organizing and self-healing
Routing capability: any-to-any unicast, broadcast, and to/from
Central Server via nearest Gateway
[Min/Average] latency per hop: 150 ms / 500 ms

Spread spectrum protocol:

TDMA / FHSS
Synchronization for communications: ad hoc, per link and distributed
Hopping speed: once per time slot
Hopping pattern: pseudorandom
Link level acknowledgements
76.8 kbps data rate with effective link throughput up to 2.6 kbps (half duplex)

RFID:

Unique 32-bit identification number
User configurable label set via Central Server GUI

Fixed Two-Way Data Commnuications

Electrical interface: 3-pin UART serial port @ 9,600 bps
Generic open-architecture API for embedded integration with third party devices and applications

Power Supply

Electrical interface: 3.6-9.0 VDC unregulated power
Energy consumption in routing/repeater mode: 1.0 mA (time averaged): 70.0 mA (peak at +14dBm)

Physical Characteristics

Operating temperature: -40ºC to +85ºC
Weatherproofing: silicon coating
Dimensions: 30.0 mm x 65.0 mm
Mounting screws holes